Installation instructions:
F/A-18C Superpit version 2.1, released
Nov 2004
This version is intended for a variant of
SP3/SP4/FF2/BMS/FF3/FF5. So that means you
have properly installed Falcon 4.0,
patched with one of the above prior to installing the
superpit. Note that only the BMS/FF3 installs allow autoscaling, therefor it is
possible to fly in lower resolutions. The other variants are for 1600x1200 res
only.
F/A-18C pit installation
Step 1
Run the F18C_installer, and
point F4patch to the correct .exe
Step 2
Select the variant of your
installation and apply
Step 3
Run Falcon and select a F/A-18C
to fly
F/A-18C nightpit installation
Step 1
Run the Superpits.exe on your
desktop and
point F4patch to the correct .exe
Step 2
Select the nightpit and apply
Installation instructions for Red Viper
and FF5 only:
F/A-18C Hornet cockpit in
Falcon 4.0 with Red Viper and FF5:
Step 1
Run the F18C_installer, and
point F4patch to the RedViper.exe
Step 2
Select FF3 and apply.
Step 3
Go to Falcon4\art\ckptart\F18C,
copy the content and paste it into Falcon4\art\ckptart\FA-18C
Step 4
Open art\ckptart\FA-18C\16_ckpit.dat
(rightclick and open with Wordpad)
Step 5
Change the line in the
'manager' area to: cockpit2d 2300 2300;
Step 6
Save the datfile and select
an F/A-18C Hornet to fly.
F/A-18C nightpit installation
(backlit panels) in Falcon 4.0 with Red Viper:
Step 1
Run the Superpits.exe on your
desktop
Step 2
Select the F/A-18C nightpit
and apply.
Step 3
Copy the Falcon4\art\ckptart\FA-18C
dir to Falcon4\art\ckptartn
Step 4
Copy the content of
Falcon4\art\ckptart\F18C to Falcon4\art\ckptartn\FA-18C
Step 5
Run Falcon and select
an F/A-18C Hornet to fly at
night.
SAVE & SHARE